Tesla Cybercab: Engineering a New Approach to Manufacturing

The Tesla Cybercab introduces a different approach to vehicle architecture and production. From its unboxed construction to its integrated vehicle systems, the Cybercab challenges conventional thinking about how a vehicle is designed, assembled, and serviced.

During a Munro Live visit to Tesla, Lars Moravy, Vice President of Vehicle Engineering, and Eric Earley, Cybercab Chief Engineer, led a technical walkthrough with other members of Tesla’s engineering and manufacturing teams.

Rather than building the vehicle as one continuous structure, Tesla separates the front, rear, and side sections into independent modules, allowing components to be installed and tested before final integration. The production line is 78% automated, with approximately 25 final assembly stations, and is designed to reduce floor space per unit of output by 50%.

Tesla’s approach to the front module brings key vehicle systems together in a single assembly, including the drive unit, power electronics, and thermal management, with service access built into the design. The battery pack follows a similar approach, allowing individual sections to be serviced without replacing the entire pack. Its architecture leaves room for potential changes in cell chemistry, including LFP.

These design decisions extend from the vehicle’s architecture to the way it is manufactured and serviced. The Munro Live walkthrough with Tesla’s engineering team provides a closer look at the decisions behind the Cybercab, including details that are difficult to capture in a written summary.

Watch the full video to see the engineering firsthand.